The webbing anchors are made for 25mm polyester or polyamide webbings. These heavy-duty anchors also provide safe rigging for longlines over 100m.
The side plates, axles, bolts are made from high-strength stainless steel for maximum safety and durability. The 28mm diameter middle roller is made from hard anodized 7075 aluminium alloy. It is secured with an extra bolt to make its use safer, and prevent from turning around under high loads, which can make the webbing slip off. Because of its big diameter the roller makes the locking with the webbing highly efficient.
The front pin is made from high-strength stainless steel.
WLL (working load limit): 10kN (at safety factor of 5)
MBS (tested minimum break strength): >50kN
sideplates: 4mm thick 1.4301 Stainless Steel
front pin: 12mm diameter 1.4571 Stainless Steel
middle roller: changing diameter hard anodized 7075 aluminium alloy
middle axle: 12mm diameter 1.4571 Stainless Steel
inner width: 25.5mm
weight: 313g
The LINK 2.0 webbing anchor can accommodate Stainless Steel and alloy steel Bow and Dee shackles up to 16mm pin / bow diameter. Thanks to the unique anchor hole design all shackles can be freely rotate whether you want it to be connected with the bow or pin side to the anchor. Carabiners can also be rotated up to 16mm lockring diameter. This is a mayor advantage when using a LINK 2.0 webbing anchor compared to many others on the market.
